Assembly instructions, Operation – Bolens 248-604A User Manual
Page 4
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ASSEMBLY INSTRUCTIONS
1.
Remove the log splitter, parts pack all literature
from the crate before discarding crate.
2.
Block up rear end of log splitter so that the rear
wheels may be assembled.
3.
Place flat washers (A) on axle, then wheels and
secure with collars and set screws (B). See figures
1 and 2.
I
FIGURE 1
4.
The engagement handle is partly assembled, pivot
handle upward into position and secure with
shoulder bolt (C). See figure 3.
ENGAGEMENT HANDLE
SHOULDER BOLT (C)
SHOULDER BOLT
ALREADY IN
POSITION
FIGURE 3
5. Tighten both shoulder bolts securely.
OPERATION
1. Service engine with gas and oil. See engine manual
packed with log splitter for complete instructions
for the care and maintenance of engine. READ
DIRECTIONS CAREFULLY.
A
CAUTION
You must not operate log splitter
without
proper
amount
of
oil
in
reservoir tank.
FIGURE 2
2. Remove the breather cap from reservoir tank.
See figure 4.