Beko 32WLA530HID - Manual (Page 26)

INTRODUCTION
Because your LCD-TV equipment is provided with VGA inputs, it may be used os o PC monitor os
well. (Plug&Play)
Connecting PC:
Connect your PC through the D-Sub connector
and an appropriate cable (not inicuded with
your TV) to PC-IN input the back of the TV.
Again using an appropriate cable you can
connect your PC sound output to the AUDIO IN
input on the back of the TV and listen to sound.
Transition to the PC mode
In order for the LCD-TV to switch to the monitor
(PC) mode, you can press the (O) button on your
remote control and by using the (^i^) (
1 > 5 )
buttons, you must select PC and then press' ''
(f;5)). In order to switch from the PC mode back
’ * ryfsXiT
to the TV mode, use the (O) button on your
remote control.
PC Input Settings
You can enter the picture setting menu by pressing
the (O) then (t^) while in PC mode. In order to
make the necessary adjustments in this menu,
you can use the right-left, up-down direction
( ) ( ), ( ) or (• '^ ) buttons on your remote
control to alter brightness and contrast as well
as other adjustments for the monitor listed below.
H.Position: Horizontal position setting
V.Position: Vertical position setting
PHASE: Using the Right/left ( ) or ( )
buttons you can adjust colour and shape.
Picture Format: You can select the PC image
in the 16:9, 4:3 or 1:1 formats.
You can make your choices without entering the
picture menu by using the format button on your
remote control.
Automatic Position: The most suitable
geometric settings in accordance to the entry
mode is configured by this function. For this
application, choice the AUTO Position option
and press the (•.,:') button.
In PC mode you are able to use PIP as mentioned
in the sections above.
You can adjust the volume of the device you
connect to the Audio-In input at the back of the
TV by using the (j^) or /(®) buttons.
m
1
/
kT
Brightness 0-i------------------------
Contrast 0-i------------------------
H Position lOO-i------------------------
V Position O-i-----------------------
Phase 0-i------------------------
Auto Position
In PC mode, HDMI and YUV modes can't be
displayed (PC-HDMI, PC-YUV) for PIP function.
-
26
-