Read these instructions before use, Getting started, Aerial connection – Beko 32WLA530HID User Manual
Page 7: Switching on and first use
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Getting started
Remove your Television carefully from the box.
You may wish to store the packaging for future
In the box
Inside the carton box you should have:
• Accessories box
• Power cord
• Remote control
• Batteries
• Instruction Book
Note:
Scarf,
VGA,
PHONO
and
HDMI
Leads are not supplied.
Read these instructions before use.
Aerial connection
To connect an aerial, plug the aerial lead
into the aerial socket on the rear of the
TV.
1. The availability of Freeview digital terrestrial
services in your home depends on your local
transmitter and the configuration of your existing
reception equipment.
2.
You should have already checked your postcode
to see if you are in a Freeview coverage area.
If not please contact Freeview immediately:
Call 08708 809980
Text your postcode to 83331
3.
If you are in a Freeview coverage area but
are unable to receive all available channels for
your location, it is recommendded you have a
site survey by a professional aerial installer to
ensure aerial alignment and line of site' to the
transmitter are optimised. If you do not know of
a
local
aerial
installer,
please
call
the
on 0208 902 8998 who will be able to
recommend one.
You con use on outdoor or indoor aerial.
However, if you use an indoor aerial the quality
of the reception may be reduced and adjustment
of the aerial may be required when changing
programs.
Please note
If you live in a poor reception area or use an
indoor aerial you may experience loss or
corruption of teletext transmissions.
Switching on and First Use
1. Connect the mains lead to the socket at the
back panel of the LCD TV.
2.
Connect the mains plug to a suitable mains
socket.
Note 1
: Your TV will go to stand-by mode
in five minutes if there is no broadcast signal.
Note 2:
Your TV is equiped to operate from the
control buttons on the cabinet. In case your R/C is
broken or the batteries are exhausted.
Pleose Note
When not in use disconnect the mains plug from
the mains supply.
3.
Press the
Power
button on the cabinet
of the TV. The standby indicator will
illuminate.
4.
Press a numeric button or the
Program
Up
/
Program Down
button on the
remote handset or
Program Up /
Program Down
on the cabinet of the
TV to switch the TV on. The picture will
appear after a few seconds.
Pleose Note
Do not leave the television in standby unattended
or overnight.
Switching the TV on for the first time
To install your TV, please read the sections
"TV controls" and "Tuning the television".
The botteries
Remove the back cover to reveal the battery
compartment and make sure you insert the
batteries the right way round.
Suitable battery types for this remote are
UM4, lEC R03 or AAA 1.5V.
Do not throw your old batteries into a fire,
dispose of them in a designated disposal area.
Do not combine a used, old battery with a new
one or mix battery types.
The performance of the remote control will
deteriorate beyond a distance of 8 metres or
outside an angle of 30 degrees from the centre
of the TV.
r
-
7
-