Bryant 463AAC008BA - Manual (Page 13)

installation instructions
9. Secure Shutters
A Carefully slide the air conditioner back into the cabinet.
(Please seek assistance for this procedure)
Reinstall the slide-out-chassis security screws (removed
earlier) on both sides of the cabinet See {Fig 19)
Secure the top of the frames to the window sash
with (2) 3/4” screws
B Now, secure bottom frame of shutters using one shutter
clamp and one 3/4" screw on each side(F/fir 19).
10. Reinstalling Front Panel and Air Inlet Grille
(Model 463AAC005BA):
A Position the front panel on the cabinet starting at the
top The front panel lock tabs must be inserted into the
retaining slots in the cabinet Repeat this procedure on
all sides
B Secure the front grille to the cabinet using the Philips
screws removed eariier(Fig 20)
C Replace the air filter
D Position air inlet grille on the cabinet and gently
press on it
11. Reinstalling Front Panel Assembly
(Model 463AAC008BA)
A Position the front panel on the cabinet starting at the
top The front panel lock tabs must be inserted into the
retaining slots in the cabinet Repeat this procedure on
alt sides
B Secure the front grille to the cabinet using the Philips
screws removed earlier(F/g 21)
ng 22
12. Complete the installation
A Cut the second foam seal to fit the opening between
the top of the inside and outside window See {Fig 22)
B Some installations may require additional sealing around
the window and air conditioner Check for any air teaks
and seal where necessary
C In very humid areas, the water removal may be excessive
enough to overflow the unit or increase the noise of the
air conditioner If this occurs, you may wish to attach a
drain hose (not included) to the drain plug allowing
condensations to run off conveniently See (Fig 23)
—
12
-
Rg 23