Bryant 463AAC008BA - Manual (Page 15)

Care and Maintenance
When servicing the air conditioner, be sure to
turn the mode switch to the "OFF” position and
disconnect the power cord from the electncai outlet
1 DOT NOT use gasoline, benzine, thinner or
other chemicals on the air conditioner as these
substances may cause damage to the paint finish
and deformation of plastic parts
2 Never attempt to pour water directly to the
front of the unit as this will cause deterioration of
the electrical insulation
CAUTION
DO NOT forget to install thé air filter If the air
conditioner is left to operate without the air filter,
dust is not removed from the room and may
cause your air conditioner to fail
When the air filter inlet grill and cabinet are dirty,
wipe with lukewarm water (below 40°C) Use of
mild detergent is recommended
Cleaning the Air Filter
Removal of Air Filter
If the air filter becomes clogged with dust, air-flow
is obstructed and reduces efficiency The air filter
should be cleaned once a month More frequent
cleaning may be necessary depending on outdoor
and indoor air quality
Air Filter Removal,
(Model 463AAC005BA)
The air filter on the above models is located
behind the air intake front grill To remove the
air filter, locate the finger indents on bottom
side of air inlet grill Pul! forward and lift off
front grill To remove the air fitter, grasp the
filter handle, lift and pull fonA/ard To reinstall
the air filter, reverse the above procedure
The air filter may be vacuumed or washed
by-hand in warm water Dry thoroughly before
installing
Air Filter Removal
(Model 463AAC008BA)
The air filter on the above models is located
behind the air intake front grill
To remove the air filter, grasp the filter hand!e(tab)
located on the right (center) side of the air inlet grille
and slide the air fitter to the right
To reinstall the air filter, reverse the above
procedure
Cleaning of Air Filter
1 Remove dust clogged in the filter by
tapping it or vacuum clean it
2 Wash the fitter well with lukewarm water below
40*^0 (104‘’F) while rubbling lightly To get better
results, wash it with soapy water or a neutral
cleaning agent
3 Rinse the filter well using clean water then
dry completely
End-of-Season Care
1 Operate the fan alone for half a day to dry out
the inside of the unit
2 Turn off power and remove plug from wall socket
3 Clean fitter
4 Store in a dry location
-
14
-