Audiovox DT921C - Manual (Page 20)

__ _ - . -__ __ __
You can make calls directly from the
handset whether you are at the base
or away from it.
NOTE; There are two different ways
to dial a number;
Press the TALK key and wait for
dial tone. Then dial the number you
want.
Or
You can use your AUDIOVOX DT921 c
cordless phone with services such as
Call Waiting. Simply press the TALK
key to FLASH the line.
To REDIAL the last number you
dialed, press the TALK key, then press
REDIAL . The phone will automatically
dial the number. The number will be
shown on the display.
2. Enter the number onto the display
first, then press the TALK key.
This will dial the number that is
displayed on the LCD after 2
seconds.
See "ADVANCED
DIALING" on Page 22
If you make a mistake when dialing,
press OFF to hang up, then press
the TALK key to get the dial tone
again.
to end a call, either place the handset
back in the base, or press OFF on
the handset.
When the Handset rings, press any
key other than OFF, MUTE or the
VOLUME keys to answer your call.
The volume controls for the handset
are located on the side of the unit.
Press the (up) or y (down) keys
to increase or decrease the volume.
Holding either key down will
continuously change the volume
setting. The earpiece volume level
indicator on the LCD will change
accordingly. There are four volume
levels.
The display can be cleared by pressing
and holding the CLR/DEL key down
until the display clears.
Press MUTE during conversation
to disable the handset microphone.
Press MUTE again to return to
normal operation.
Press ~MUTE during incoming
ringing to disable the ringer for the
duration of the call.
Press HOLD to place an active call
on hold. ’
The LCD will display CALL ON
HOLD.
Press HOLD again to return to the
call.
i?<G^ANbSET?ir0CAtQRfc^^
To page from the Base Unit, press
PAGE.
. The LCD will display BASE PAGING
HANDSET.
To cancel the page, either press
PAGE again on the Base Unit, or
press OFF on the Handset.
Vi:.-
20
di92l.p63 20 1998/6Г22. P.M 07:22