Audiovox DT921C - Manual (Page 31)

NQISË OR INTERFERENCE.
Your AUDIOVOX dtasic cordless
telephone has auta-channel scan
circuitry which wlii detect excess noise
and change the channel ot the phone
lo reduce it> This Is done automatically.
Since the AUDIO VOX OT921c is a fully
digital phone, it does not suffer from
noise associated with regular cordless
phones. At times you may experience
occasional 'drop outs', especially at
the extreme edges of the phene's
range. Simply move closer to the base
unit and this wlii disappear.
AUTOMATIC SECURITY CODING
Your AÜDIOVOX DT9£tc phone is
factory set with t6.e million possible
security codes. This unique security
cede allows your handset and base lo
recognize each other, and minimizes
the posslbUity о F another cordless
phone using your telephone line.
OUT OF RANGÉ INDICATION
If the handset is moved to a point where
the base and handset can no longer
communicate, the handset will mahe a
quick series of beeps tc signal Out of
Range,
if the handset is active when taken
oul-of-range. it will beep twice a
second and enter standby mode after
25 seconds if the fink !s not
reestablished. It the handset is
brought back within range, it wilt
automatically re-link.
For out'of-range In standby mode, the
handset will beep once and then at T5
second
intervals, will display
"CHANNEL SERACHING' on the
LCD, and scan ail channels in an
attempt to re-llnk with the base.
CHRHHEL
SERRCHING
OUT OF RANGE WHEW PHONE IS
ON
I
if you are presently engaged In a phene
conversation move closer to the base.
If the base unit does not communicate
with the handset within
25 seconds of
losing contact, it will automatically
hang up.
OUT OF RANGE WHEN PHONE IS
OFF ■ ¿i..-
If the phene is OFF, the handset and
base still monitor each other to make
sure that they can communicate, if the
handset is moved out of range, the
handset will make a series of beeps,
and will then display ‘CHANNEL
SERACHING" on the LCD. At IS
second Intervals the handset will scan
all channels in an attempt to reestablish
communication with the base. This
process does not require user
(nlerventjon; the handset will re-lfnk
with the base automatically once it is
brought back within range. The unit
will then be able to receive and place
calls.
When the base unit is unplugged from
the power supply, the handset will give
the 'Out of Range' warning beep. Plug
the base in again and this will step.
31
ifliiM, IT:i3 A*J