Aiwa AV-X200 - Manual (Page 11)

RADIO RECEPTION
MANUAL TUNING
MONO
TUNER
oo
ooood)
ooooo
ooooo
qD
oooo
oooo#>
ooooo
oQ oo
COD oo
ou oo
ooooo
1 Press the TUNER button repeatedly to select the
desired band.
FM------ ► AM ■
□
If the power is turned off, the previously tuned station will be
played (Direct Play Function).
Press the UPA or DOWNT button to select a
station.
E:ach time the button is pressed, the frequency changes.
When a station is received, “TUNE” is displayed for two
seconds. During FM stereo reception, (K®») is displayed.
DANCF
LIVE
HALL
ARENA
s"f M
U Li MHz
/ / / /
I I i \i r
ROCK
POP
CLASSIC
BGM
DIRECT TUNING
»z
bOL
4
gs
When you know the frequency of the desired station, you can
tune in directly to the station.
1 Press the TUNER button to select a band.
2 Press the TUNER button and hold it down until
flashes on the display (Direct Tuning Mode).
i\:V
: i
llllll POCK EEa POP
■ ■ ■ ■ -'.i-ii.
rsOlv'
3 Press the appropriate numeric buttons to tune
in to the desired station.
Exampie:
To tune in to 106.50 MHz, press 1,0, 6, 5 and 0 buttons.
To tune in to 95.25 MHz, press 9, 5, 2 and 5 buttons.
To cancel the Direct tuning mode
Press the UPA or DOWNT button.
To search for a station quickiy (Auto Search)
Keep the UPA or DOWNT button pressed until the tuner starts
searching for a station. After tuning in to a station, the search
stops.
To stop the Auto Search manually, press the UPA or DOWNT
button.
• The Auto Search may not stop at stations with very weak
signals.
' When entering a frequency out of tuning range, the value
flashes for two seconds and then goes off. Check the frequency
and repeat step 3 correctly.
' When entering a frequency not covered by the tuning interval,
the value is automatically rounded up or down to the closest
one covered by it.
When an FM stereo broadcast contains noise
Press the MONO TUNER button on the remote control so that
“MONO” appears on the display.
Noise is reduced, although reception is monaural.
LIVE
HALL
i\ /1
! I
MONO
f ? i ; ! , ,
? /
!/
ROCK
POP
JAZZ
To restore stereo reception, press the button so that MONO
disappears.
To change the AM tuning intervai
The default setting of the AM tuning interval is 10 kHz/step. If
you use this unit in an area where the frequency allocation system
is 9 kHz/step, change the tuning inten/al.
Hold down the TUNER button and press the POWER button
immediately. Note that the unit is set to the Direct Tuning mode
if the TUNER button is pressed and held down for about two
seconds.
To reset the interval, repeat this procedure.
ENGLISH
10