Aiwa AV-X200 - Manual (Page 13)

DOLBY PRO LOGIC
The Dolby Pro Logic feature and the center and surround
speakers (standard) assure full-scale home theater sound. When
playing back laser discs or video software that have been
specially recorded with four-channel sound (left, right, center,
surround) and steering logic (for directing sound), astonishingly
realistic sound surrounds the listener to create a new level of
audio/visual entertainment.
Independent control of the four channels allows the listener to
enjoy the same type of sound reproduction experienced in movie
theaters. Voices are reproduced in the front and center sound
field, while ambient sounds like cars and crowds are reproduced
on all sides of the listener for an incredibly lifelike audio/video
experience. Please read the following carefully to “tune” the
system’s output to match the characteristics of your listening
space.
The recommended mode
Center speaker
Larger-size Smaller-size No speaker
Surround speaker
(Rear speaker)
DOLBY PRO
LOGIC-WIDE
DOLBY PRO
LOGIC-NORMAL
PHANTOM
No surround
speaker
ЗОН LOGIC­
WIDE
ЗОН LOGIC-
NORMAL
-
§
£
PHANTOM mode; Select this mode when the center speaker is
not connected. All center channel signals are redistributed to
the left and right channel speakers.
3CH LOGIC mode: Select this mode when the surround
speakers are not connected.
О
О
о
Q-I
<о
CCQ
Check the following:
• Before using the DOLBY PRO LOGIC, adjust the proper
balance of the speaker sound levels (see page 13).
• Make sure the speakers are properly connected and positioned
(see pages 3 and 4).
• Make sure the TV set and video unit are properly connected
(see page 3).
•Make sure the laser disc and video tape, etc., support
I III DOLBY SIWROUM d ] ^
SELECTING DOLBY PRO LOGIC
The optimal Dolby Pro Logic mode depends on the type and
placement of the speakers. It is recommended that the optional
Aiwa speakers should be used for all channels, the SX-R260 for
surround speakers, the SX-C500 for a center speaker and the
SX-AV500 for front speakers. Check your current type and
placement of the speakers and select the recommended Dolby
Pro Logic mode accordingly.
TO SELECT A DOLBY PRO LOGIC MODE
Press the DOLBY PRO LOGIC button repeatedly
to select the appropriate mode.
When selecting the DOLBY PRO LOGIC or 3CH LOGIC
mode, the indicator lights up, and the selected mode name
runs through on the display. Each time the button is pressed,
the mode changes as shown below.
ROCK
POP
(a) Front speakers
(b) Center speaker
© Surround speakers
c
DOLBY PRO LOGIC----► 3CH LOGIC —
DOLBY PRO LOGIC oFF (cancel)
2 Press the DOLBY PRO LOGIC button again and
hold it down untii the center speaker mode to be
seiected appears.
When selecting the DOLBY PRO LOGIC mode in step 1:
“NORMAL”, “WIDE” and “PHANTOM” appear in turn.
When selecting the 3CH LOGIC mode in step 1:
“NORMAL’ and “WIDE” appear one after another. •
• Depending on the sound source or listening condition, surround
effect may not be obtained even when the DOLBY PRO LOGIC
is on.
• The full DOLBY PRO LOGIC effect cannot be obtained when
using the software without mi°«gvsunmuw°l mark. In this case,
use the DSP surround system instead (see page 8).
• The DOLBY PRO LOGIC system is automatically canceled
when the BBE or DSP system is turned on.
ENGLISH
12