Aiwa AV-X200 - Manual (Page 18)

TROUBLESHOOTING GUIDE PARTS INDEX
If the unit fails to perform as described in these Operating
Instructions, check the following guide.
GENERAL
There is no sound.
• Is the AC cord connected properly?
• Is there an incorrect connection? {-► page 3)
• There may be a short circuit in the speaker terminals.
-» Disconnect the AC cord, then correct the speaker
connections.
• Was an incorrect function button pressed?
• Are the FRONT SPEAKERS A and B buttons set correctly?
(-* page 6)
Sound is emitted from one speaker oniy.
• Is the BALANCE control set appropriately?
• Is the other speaker disconnected?
Sound is heard at a very iow volume.
• Has the MUTING button been pressed?
An erroneous display or a malfunction occurs.
Reset the unit as stated below.
TUNER SECTION
There is constant, wave-like static.
• Is the antenna connected properly? (-» page 5)
• Is the signal weak?
-+ Connect an outdoor antenna.
The reception contains noise interference or the sound is
distorted.
• Is the system picking up external noise or multipath distortion?
Change the orientation of the antenna.
Move the unit away from other electrical appliances.
Instructions about each part on the unit or remote control are
indicated on the pages listed bellow.
(in alphabetic order)
Parts
ADDRESS
AUX/TV
BALANCE
BBE
CD
CLOCK
DOLBY PRO LOGIC
DOWN T (◄)
DSP
FRONT SPEAKERS A, B
GEQ
LEARN
MANUAL SELECT (TEST)
MEMORY
MONO TUNER
MUTING, MUTE
PHONES
POWER
SET
SLEEP
TAPE MONITOR
T-BASS
TUNER, BAND DIRECT
UP A(^)
VIDEO 1
VIDEO 2, LD/MD
VIDEO 3
VOLUME
Pages
14
6, 9
7, 13
7
6, 9
6
12
6, 8, 10, 11, 13, 15
8
6, 9
8
14
13
14
10
7
6
6
6,11
14
6. 9
7
6, 9, 10, 11
6, 8, 10, 11, 13, 15
6.9
6.9
6.9
7
To reset
If an unusual condition in the display window or malfunction
occurs, reset the unit as follows.
1 Press the POWER button to turn off the power.
2 Press the POWER button while pressing the SET button.
Everything stored in memory after purchase is canceled.
If the power cannot be turned off in step 1 because of a
malfunction, reset by disconnecting the AC cord and repeat step
2 .
17
ENGUSH