Compaq 4000N - Manual (Page 36)

Chapter 3 Processor/Memory Subsystem
Compaq Deskpro 4000N and 4000S Personal Computers
First Edition - September 1997
3-2
Mem.
Data Bus
Mem. Addr.
3.2 PENTIUM MMX-BASED PROCESSOR/MEMORY SUBSYSTEM
The processor/memory subsystem is based on the Pentium MMX microprocessor, a 512-KB or 1-
MB secondary cache, and a VT82C595 system controller (Figure 3-1).
Figure 3–1. Processor/Memory Subsystem Architecture
The microprocessor is mounted in a ZIF type 7 socket that facilitates easy changing/upgrading.
The system supports both 2.8V and 3.3V core processors. Replacing the microprocessor may
require reconfiguring a DIP switch to select the correct bus frequency/core frequency
combination. Frequency selection is described in detail later in this section.
The VT82C595 system controller provides the Host/PCI bridge functions and controls transfers
with the 64-bit memory data bus. The system includes 256 kilobytes of SRAM controlled by the
system controller as a direct-mapped, write-through L2 cache to the L1 cache integrated into the
microprocessor. The system supports synchronous, pipelined burst SRAM/DRAM for the L2
cache, providing 3-1-1-1 read/write cycles at 60 and 66 MHz on a cache hit.
The standard system memory configuration consists of 16 or 32 megabytes of SDRAM system
memory. The system memory can be expanded to 256 megabytes.
Pentium MMX
Microprocessor
32-bit PCI Bus
256-KB
Secondary
Cache
Optional module
16-MB
DIMM
J7 J8
System Memory
64-Bit Host Bus
Cache/
Memory/PCI
Controller
(VT82C595)
Cntl
Cntl
Memory/PCI
Data Buffer
()
DIMM