Adams Condensing Oil-Fired Furnace - Manual (Page 3)

1. Component Identification
H IG H LIM IT
> faRIMARY OIL CONTROL
' aURNER MOTOR
■ fUEL FILTER HEAD
FUEL FllTER CARTWOCE
auxiliary ÜMET
MANUAL RESET
CONDENSATE COLLECTOR
BLOWER DOOR
INTERLOCK SWTCH
Figure 1
II. SAFETY
Please adhere to the following
warnings and cautions when
installing, adjusting, altering,
servicing, or operating the furnace.
Important
The following In^Fumerrts must be used to
adjust the burner on startup.
Fatture to use the proper tn^niments will void
our warranty and will result in an
luisatisfactory Installation.
Bacharach Electronic Combustion Analyzer
Bacharach Smoke Tester
(Or equivalent to above)
Oil Pressure Gauge
WARNING
TO PREVENT PERSONAL INJURY OR
DEATH DUE TO IMPROPER
INSTALLATION, ADJUSTMENT,
ALTERATION, SERVICE OR
MAINTENANCE, REFER TO THIS
MANUAL. FOR ADDITIONAL
ASSISTANCE OR INFORMATION,
CONSULT A QUALIFIED INSTALLER,
SERVICE AGENCY OR THE FUEL OIL
SUPPLIER.
WARNING
HIGH VOLTAGEI
TO AVOID PROPERTY DAMAGE,
PERSONAL INJURY OR DEATH DUE TO
ELECTRICAL SHOCK, THE FURNACE
MUST BE LOCATED TO PROTECT THE
ELECTRICAL COMPONENTS FROM
WATER.
WARNING
DO NOT UTILIZE THE HEATING UNIT
WITHOUT REASONABLE ROUTINE
INSPECTION, M/UHTENANCE AND
SUPERVISION. IF THE UNIT IS IN A
BUILDING THAT IS OR WILL BE
VACANT, CARE SHOULD BE TAKEN TO
ROUTINELY INSPECT, MAINTAIN AND
MONFTOR THE UNIT. IN THE EVENT
THAT THE BUILDING MAY BE EXPOSED
TO FREEZING TEMPERATURES AND
WILL BE VACANT, DRAIN ALL WATER­
BEARING PIPES, PROPERLY WINTERIZE
THE BUILDING AND TURN OFF ALL
WATER SOURCES. IN THE EVENT THAT
THE BUILDING IS EXPOSED TO
FREEZING TEMERATURES AND IS
VACANT, ANY HYDRONIC COIL UNITS
SHOULD ALSO BE DRAINED AND AN
ALTERNATIVE HEAT SOURCE UTILIZED.