Aiwa CSD-MD5 - Manual (Page 22)

CLOCK AND TIMER
SEniNG THE CLOCK
2,3
¥(^1.2.3
1 Press CLOCK and press ENTER within 4
seconds.
£j M
f n /
J*i rron
^11 •“ I I
-
(12-hour standard)
2 Turn JOG DIAL to designate the hour, and
press ENTER.
The hour stops flashing on the display and the minute
starts flashing.
3
Turn JOG DIAL to designate the minute, and
press ENTER.
The minute stops flashing on the display and the clock
starts from 00 seconds.
To display the current time
Press CLOCK. The time is displayed for 4 seconds.
However, the time cannot be displayed during recording.
To switch to the 12/24-hour standard
While the current time is displayed, press ■.
If the clock display flashes
This is caused by a power interruption. Set the current time
if it is not correct.
if power is interrupted for more than 10 hours, all settings
stored in memory after purchase need to be reset.
During operation
JOG DIAL.
and are also available instead of
SETTING THE TIMER
The unit can be turned on at the specified time every day
with the built-in timer.
Timer recording is applicable for TUNER source only.
2.3.4,5
■TIMER
■ ENTER
Preparation
Make sure the clock is set correctly.
7
Press TIMER once or twice so that TIMER PLAY
or TIMER REC is displayed and press ENTER
within 4 seconds.
The hour flashes.
(Example: Timer play)
Fim ;;тгн^т
til] •..
Oit»
t" n I
■ s ■
(Example: Timer recording)
REC 5J№C\
? OM JS ”ifb n ^—
’ / / / / icJpu \
2
Designate the hour of the timer-on time with
JOG DIAL and press ENTER.
Repeat to designate the minute of the timer-on time.
After you designate the timer-on time, one of the source
names is displayed.
3
Select a source with JOG DIAL and press
ENTER.
To set the timer recording, skip this step.
CD MD — TUNER □
22
ENGLISH