Aiwa CSD-MD5 - Manual (Page 8)

MD PLAYING
BASIC OPERATIONS
■ STOP
AMD
EJECT
DISP
0-15,+10
1
Insert a disc into the disc drive with the iabei
side up and in the direction of the arrow.
Arrow
O
2
Press MD ^11 to start piay.
Track number or track title*
Ti-acji______
nnnr
■5,'t
or
Track number Elapsed playing time
* applicable when the track title is registered.
To stop play, press ■ STOP, MD ■ on the remote control
is also available.
To pause play, press MD ►II. To resume play, press
again.
To search for a particular point during play, keep
►W pressed and release it at the desired point.
To skip to the beginning of a track, press or
repeatedly or turn JOG DIAL until the desired track is
displayed.
To remove the disc, press ± MD EJECT.
To start play when the power is off
Press MD ►!!. The power is turned on and play of the
loaded disc begins.
To check the remaining time
During play, press DISP repeatedly.
Each time it is pressed, the display changes cyclically.
I
® Elapsed playing time of the track
i
(D Remaining time of the track
(D Remaining time of the disc
® TRACK is lit up on the display.
@ TRACK and REMAIN are lit up on the display.
(3) TOTAL and REMAIN are lit up on the display.
You cannot check the remaining time of the disc when
RANDOM or Ci. 1 is lit up.
To select a track with the remote control
Press the numbered buttons 0-15 and +10.
Example:
To select the 25th track, press +10 twice and 5.
To select the 20th track, press +10 twice and 0.
MD play starts from the selected track and continues to the
last track.
To play a disc at double speed
Press X 2 on the remote control during play.
To resume normal play, press again.
When using the main unit, keep MD ►!! pressed during
regular play until disc plays at double speed.
To resume, repeat the above.
Display information in stop mode
Total number of tracks or disc title*
^¿KSr PCV* MZ
u
/ /
/ ir.ljl 1
IJ- lU
1
Total number of tracks Total playing time
* applicable when the disc title is registered
TOC READING is displayed while:
The unit reads the data on the inserted disc. After
completion, the information contained in the disc is
displayed.
NOTE
Do not open or close the operating panel while ejecting the
disc, otherwise a disc may be scratched.
Do not hold the disc while ejecting it, otherwise a disc
cannot be inserted the next time.
If this happens, turn off the power and disconnect the AC
cord. Then connect it again.
Nothing other than an MD should be inserted into the disc
drive. Otherwise the disc may become scratched, causing
a malfunction or safety hazard such as an electric shock.
Do not attempt to insert another MD while a disc is already
inside the drive.
Do not tilt the unit with disc loaded. Doing so may cause
malfunction.
8 ENGLISH