Aiwa CT-FX929M m - Manual (Page 8)

PRESETTING STATIONS
To preset stations automatically
(auto memory)
1
InrllM t\ nl?
Press BAND to select a desired band
from among F1 (FM1), F2 (FM2), F3
(FM3), A1 (AM1) and A2 (AM2).
2
Press and hold A.ME for more than 2
seconds to activate the automatic
presetting function.
The six strongest available stations will be
stored in memory on the preset station buttons
1 to 6 in order of their signal strength. The “A
MEM” indication appears while the unit is in
this mode.
Use this function to automatically preset up to 6
stations each for FI, F2, F3, A1 and A2 (up to a
total of 30 stations).
•When auto memory is completed, the preset
stations are automatically tuned in for 5 seconds
each in order.
•To stop auto memory, press A.ME again.
To check the preset stations (preset scan)
• If you wish to check the preset stations, press
A.ME for less than 2 seconds. The preset stations
stored in memory will be tuned in for 5 seconds
each in order.
• To stop this function, press A.ME again or press
any of the preset station buttons 1 to 6.
To preset stations manually
You can manually preset stations that have not
been selected by auto memory.
2 1
Press BAND to select the band from
among F1 (FM1), F2 (FM2), F3 (FM3), A1
(AM1)and A2 (AM2).
Tune in the station that you wish to
preset with TUNE T or TUNE A.
Press one of the preset station buttons
1 to 6 for approximately 2 seconds.
The number of the pressed preset station
button appears next to the frequency
indication.
Preset number
Repeat these procedures to preset up to 6 stations
each for F1, F2, F3, A1 and A2.
• If you try to preset a station on a preset station
button on which another station of the same
band has already been preset, the previously
preset station will be erased.
During presetting of stations, beeps are heard
regardless of the beep on/off setting (page 16).
7
ENGLISH