ADLINK aTCA-N700 - Manual (Page 14)

Switch Manager Configuration Guide
14
4.2.3 Clear Configuration
The following commands allows you to clear counters on the specified port.
Command description
clear port [PORT_ID]
counters
Clear counters of specified port
Example
Clear counters on port xe0.
4.2.4 Restore
Command “restore” can reset start-up configuration to factory default. Do not use this command
unless you are clear on what it does. You should reboot the switch blade after executing this
command to make it effective.
The following command allows you to to reset configuration to factory default.
Command description
restore Reset start-up configuration to factory default.
4.2.5 Command List
Command “list” can print all commands which are available in Configure Mode.
The following commands are available for printing command list.
Command description
list Print command list.
ATCA-N700# clear port xe0 counters
ATCA-N700)# show port xe0 counters
Statistics of port 1 --
Bytes Received: 0(Bytes) Bytes Transed: 0(Bytes)
Bytes RX Rate : 0(Bps) Bytes TX Rate: 0(Bps)
Pakts Received: 0(packets) Pakts Transed: 0(packets)
Pakts RX Rate : 0(pps) Pakts TX Rate: 0(pps)