ADLINK Express-BE - Manual (Page 18)

Page 18 Express-BE
3.3. AB Signal Descriptions
3.3.1. Audio Signals
Signal Pin # Description I/O PU/PD Comment
AC_RST# /
HDA_RST# A30 Reset output to CODEC, active low. O 3.3VSB
AC_SYNC /
HDA_SYNC A29 Sample-synchronization signal to the CODEC(s). O 3.3V
AC_BITCLK /
HDA_BITCLK A32 Serial data clock generated by the external
CODEC(s). I/O 3.3V
AC _SDOUT /
HDA_SDOUT A33 Serial TDM data output to the CODEC. O 3.3V
AC _SDIN[2:0]
HDA_SDIN[2:0] B28
B30 Serial TDM data inputs from up to 3 CODECs. I/O 3.3VSB AC_SDIN0: supported
AC_SDIN1: supported
AC_SDIN2: supported
3.3.2. Analog VGA (No VGA support)
Signal Pin # Description I/O PU/PD Comment
VGA_RED B89 Red for monitor.
Analog DAC output, designed to drive a
37.5-Ohm equivalent load. O Analog PD 150R shall also be terminated on the
carrier with 150Ω resistor to
ground close to VGA connector
VGA_GRN B91 Green for monitor
Analog DAC output, designed to drive a
37.5-Ohm equivalent load. O Analog PD 150R shall also be terminated on the
carrier with 150Ω resistor to
ground close to VGA connector
VGA_BLU B92 Blue for monitor.
Analog DAC output, designed to drive a
37.5-Ohm equivalent load. O Analog PD 150R shall also be terminated on the
carrier with 150Ω resistor to
ground close to VGA connector
VGA_HSYNC B93 Horizontal sync output to VGA monitor O 3.3V
VGA_VSYNC B94 Vertical sync output to VGA monitor O 3.3V
VGA_I2C_CK B95 DDC clock line (I²C port dedicated to identify
VGA monitor capabilities) I/O OD 3.3V PU 2k2 3.3V
VGA_I2C_DAT B96 DDC data line. I/O OD 3.3V PU 2k2 3.3V
3.3.3. LVDS
Signal Pin # Description I/O PU/PD Comment
LVDS_A0+ / eDP_TX2+
LVDS_A0- / eDP_TX2-
LVDS_A1+ / eDP_TX1+
LVDS_A1- / eDP_TX1-
LVDS_A2+ / eDP_TX0+
LVDS_A2- / eDP_TX0-
LVDS_A3+
LVDS_A3- A71
A72
A73
A74
A75
A76
A78
A79 LVDS Channel A differential pairs O LVDS
LVDS_A_CK+ / eDP_TX3+
LVDS_A_CK- / eDP_TX3- A81
A82 LVDS Channel A differential clock O LVDS