ADLINK MXC-6000 Series - Manual (Page 33)

Introduction 21
MXC-6000
device for operating system files. Installation of a CF card is
described in Section 2.4: Installing CF Cards on page 40.
1.6.8 COM Port connectors
The MXC-6000 series controller provides four COM ports through
D-sub 9 pin connectors. The COM1 & COM2 ports support
RS-232/422/485 modes by BIOS setting, while COM3 and COM4
support only RS-232. Please refer to Section B.2.5 on page 61 for
details of BIOS COM port mode settings.
Table 1-8: D-sub 9P signal function of COM ports
1.6.9 DVI-I connector
The MXC-6000 series controller provides one DVI-I connector pro-
viding connection to an external monitor. The DVI-I connector can
be separated into VGA and DVI-D (single link) interfaces using the
included ADLINK Y-cable.
PIN
Signal Name
RS-232 RS-422 RS-485
1 DCD# TXD422- 485DATA-
2 RXD TXD422+ 485DATA+
3 TXD RXD422+ N/S
4 DTR# RXD422- N/S
5 GND N/S N/S
6 DSR# N/S N/S
7 RTS# N/S N/S
8 CTS# N/S N/S
9 RI# N/S N/S