Advanced Control Technologies Specs Instructions ZTH110 (RF Controller, HandheldLED Indicator, 908.42MHz) - Manual (Page 18)

ZTH100 Operating Instructions (Version 1.26)
033005 HomePro
by ADVANCED CONTROL TECHNOLOGIES, INC.
18
SET CONFIG
Allows you to set configuration settings to a unit that supports such functionality. When you select “Set Config”, you
will be prompted with
Consult the instructions that came with the unit you are configuring as to what each parameter number configures.
After selecting parameter number (use the arrow buttons to change parameter number, then press OK), you will
be prompted:
At this point, you will have to again consult the instructions for the unit you are configuring for information on how many
bytes the parameter being set contains. Then press the 1, 2, or 4 button accordingly. At this point you will be
prompted:
Use the arrow buttons to select value, then press OK.
If you have selected 2 or 4 bytes, when asked “# of Bytes”, you will be prompted for ConfigValue 2 and if necessary
ConfigValue3 and ConfigValue4.
After selecting the value(s) you will be prompted to “Press Button On Unit”. Refer to instructions of unit on exactly
what to do in this situation as you may have to do more than simply pressing a button.
After doing so, the ZTH100 will show “Successful” or “Comm. Failed”. If the ZTH100 shows “Comm. Failed”,
simply try again or move closer to unit and try again.
4.6.3 DISPLAY CONTRAST ADJUSTMENT
“C” cancels the contrast adjustment and returns to idle.
Default contrast is 50% which is restored whenever the batteries have been removed and reinstalled.
4.6.4 SETUP ALL ON/ALL OFF
Using this menu it is possible to customize the way ALL ON/ALL OFF works. Units can be included or
excluded from all on/off commands (refer to instructions of the devices you are controlling to determine if it supports
this feature).