Advanced Control Technologies Specs Instructions ZTH110 (RF Controller, HandheldLED Indicator, 908.42MHz) - Manual (Page 9)

ZTH100 Operating Instructions (Version 1.26)
033005
HomePro
by ADVANCED CONTROL TECHNOLOGIES, INC.
9
4.2.3 EXCEEDING MODULE LIMIT.
This ZTH100 Controller supports up to 64 modules. If the user tries to add more than 64 modules to a group or scene
this message will be displayed:
However the module will be given a valid ID and it will be used as a repeater if it supports this functionality, but it cannot
be directly controlled by this ZTH100 Wireless Controller. If a secondary Wireless Controller which handles more than
64 modules (could even be HomePro’s USB to RF controller) is set up using this Wireless Controller, then the module
will be made available for control in that secondary controller.
4.2.4 ADDING UNSUPPORTED DEVICE TYPES TO THE NETWORK
Devices of other types such as Remote Controller, Static Controller, Thermostat Controller, Repeater Slave, Binary
Sensor, Multilevel Sensor, Pulse Meter, Entry Control and Non Interoperable; they just cannot be controlled by this
ZTH100. If the user adds an unknown device to the network this information will be displayed:
4.2.5 NAME A GROUP/SCENE
To name a group or scene enter the relevant menu. Then select the group/scene name to be edited.
In order to delete a name, just select the group/scene and clear the old name using “C”.
Note: Outlined area indicates “blinking” cursor.
4.2.5.1 CHARACTER SET.
The characters available for naming are: ‘A’,’B’,’C’,’D’,..,’Z’, and ’0',’1',’2',..,’9',’ ‘
Note that no lower case letters are available to the user.