Advanced Control Technologies Specs Instructions ZTH110 (RF Controller, HandheldLED Indicator, 908.42MHz) User Manual
Page 8
ZTH100 Operating Instructions (Version 1.26)
033005
HomePro
by ADVANCED CONTROL TECHNOLOGIES, INC.
8
4.2.1 ADD MODULE TO GROUP
Adding a module to a group using the menu is
done this way:
A group is a set of one or more modules that
are to be operated together as if they were
one device. More specifically, every module
that is included in a group will switch on or off
together as that group is turned on and off.
When a group is activated, each Lamp
Module in that group turns on, returning to its
last dim level – a level that in general, will
differ from module to module. Appliance
Modules may also be included in groups.
Alternatively if the group has been named, the
name shows up instead of the number. To add
more units repeat the procedure “ADD UNIT TO
GROUP”. Groups and scenes may each be
given user-defined names. See section 4.2.5 for
instructions on how to do this.
4.2.2 ADD MODULE TO SCENE.
Adding a module to a scene is done this way:
Note: A Lamp or Appliance Module may be
included as a member of several different groups,
several different scenes, or several groups and
scenes.
Note: All of the properties of groups and scenes
also apply to HomePro wall dimmers and
switches.
A scene is a combination of one or more modules, except that the controller stores not only the combination,
but also the desired dim level for each Lamp Module. The dim level is stored at the time that a Lamp Module is
added to a scene. Consequently, when a scene is activated, the Lamp Modules will all go to their previously
defined dim levels regardless of what their most recent dim level may have been. Some modules may get
brighter while others may be pre-programmed by the user to become dimmer. Because Appliance and Wall
Switch Modules are switching devices, they will either be defined as on or off when added to a scene.
Note that hitting “C” will not clear units that have already been stored in the selected scene. A module is stored in
a scene when “UNIT INCLUDED” is shown in the display.