Advanced Control Technologies Specs Instructions ZTH110 (RF Controller, HandheldLED Indicator, 908.42MHz) - Manual (Page 26)

ZTH100 Operating Instructions (Version 1.26)
033005 HomePro
by ADVANCED CONTROL TECHNOLOGIES, INC.
26
Electrical
Power Two AA batteries
Signal 908.42 MHz
Range Up to 100 feet (line of sight between the Wireless Controller and the closest HomePro Plug-In
Lamp Module, Appliance Module, or Wall Switch).
6. OTHER INFORMATION
The Wireless Controller supports 64 HomePro modules. If the user adds Z-Wave devices other than HomePro to the
network, those modules will use one of the HomePro modules identification, if they are assigned as one of the first
64 modules.
However since the protocol supports up to 232 modules it is possible to create a setup with 64 HomePro modules
and numerous modules of other types. The HomePro modules must be added to the network before other types of
modules are included. The Controller application will ignore the modules that are added after the 64th, but the protocol
will make sure that they get a valid home/module identification and that they are used as repeaters if they support this
functionality.
WARRANTY
For warranty and general product information visit our web site at www.act-solutions.com
FCC NOTICE
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
IC NOTICE
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired operation of the device.