Advanced Control Technologies Specs Instructions ZTH210 (RF Controller, HandheldLED Indicator, 868.42MHz) User Manual
Page 15
ZTH200 Operating Instructions (Version 1.26)
P/D 102406
HomePro
by ADVANCED CONTROL TECHNOLOGIES, INC.
15
If instead you press OK, you will be directed to the thermostat modes of control (i.e.. Cooling, Heating, etc.).
In each case, the remote will retrieve the current setting of the thermostat and then allow you to change that setting
(depending on what is supported by the thermostat).
4.4.3 THERMOSTAT MODES
The ZTH200 supports HEAT MODE, COOL MODE, AUTO MODE, AUTO CHANGEOVER MODE, DRY AIR MODE,
FAN MODE ONLY, FURNACE MODE, MOIST AIR MODE. Scroll left or right to select. After you have changed the
setting, press OK.
If setting was recorded, display will say “Mode Successful”. If not it will say “Comm. Failed”, in which case reorient
the ZTH200 and try again.
4.4.4 THERMOSTAT SETPOINT
The ZTH200 supports sending set points from 55
o
F to 90
o
F and from 12
o
C to 32
o
C. Scroll left or right to select desired
set point.
The ZTH200 will display set points from 40
o
F to 90
o
F or from 4
o
C to 32
o
C. Above and Below those limits and the ZTH200
will display > Max or < Min. After you have changed the setting, press OK. If setting was recorded, display will say
“Setpoint Successful”. If not it will say “Comm. Failed”, in which case reorient the ZTH200 and try again.
4.4.5 FAN MODES
The ZTH200 supports FAN MODE AUTO (high), FAN MODE ON (high), FAN MODE AUTO (low), FAN MODE ON
(low). Scroll left or right to select. After you have changed the setting, press OK.