Advanced Control Technologies Specs Instructions ZTH210 (RF Controller, HandheldLED Indicator, 868.42MHz) - Manual (Page 8)

ZTH200 Operating Instructions (Version 1.26)
P/D 102406 HomePro
by ADVANCED CONTROL TECHNOLOGIES, INC.
8
4. HOW TO USE THE ZTH200 FEATURES
4.1 MENU NAVIGATION AND SELECTION
Pushing the “Menu” button will activate the menu display.:
a. and buttons are used to navigate through the menu. All menu levels wrap
around.
b. activates the currently selected menu item and recalls information from thermostat.
c. (or Clear) cancels the currently selected item and will in most instances step back to the
previously selected menu level. If used from top menu level the Controller will return to clock
display.
The top menu level behaves like this: Using the right and left arrow buttons you can toggle right or left through the menu
selections of :
GROUPS
SCENES
TIMER
SETUP
THERMOSTAT
Top level menus wrap around, so arrow buttons in any direction will repeat menu selections. Push OK or C button to
activate display if asleep (blank).
Select any one by pressing OK. Follow instructions to set up that function (explained in following paragraphs). Using
the Clear button (C) at any time will take you back to the Time (which will auto-off after 5 seconds).
4.2 GROUPS/SCENES
The layout and behavior of the “groups” and “scenes” menus are very similar. Where they are identical, “groups” is used
as an example. Push OK or C button to activate display if asleep.
To select groups from 7 to 64 or scenes from 7 to 32 see page 28, section 5.5.2 and 5.2.3.