Advanced Control Technologies Specs Instructions ZTH210 (RF Controller, HandheldLED Indicator, 868.42MHz) - Manual (Page 23)

ZTH200 Operating Instructions (Version 1.26)
P/D 102406
HomePro
by ADVANCED CONTROL TECHNOLOGIES, INC.
23
4.6.7 RESET WIRELESS CONTROLLER
The Wireless Controller can be reset in two different ways, by “user data only” selection or “factory default”. User data
only will only reset groups, scenes and names. The Wireless Controller will still retain information about the modules
that have been added to the network. A factory default reset should be used with extreme care. Factory default will clear
the controller of all information, and it will clear groups, scenes, names and will delete all modules from the network.
5. OPERATION MODE
5.1 OPERATION DISPLAY
When the clock is displayed the Wireless Controller is in operation mode. It is from this mode the known modules can
be controlled through either groups or scenes.
5.1.1 SLAVE WIRELESS CONTROLLER INDICATION
When an underscore is shown in the left bottom corner the Wireless Controller, it is a secondary Controller with the
limitations as follows: Cannot reset unit and cannot add unit to network.
5.1.2 SCENE INDICATION.
From the operation mode press the scene prefix button “S”. The display will change to:
This indicates that the next button press (number pad) will be used to control a scene (if any available).