Advanced Control Technologies Specs Instructions ZTH210 (RF Controller, HandheldLED Indicator, 868.42MHz) - Manual (Page 20)

ZTH200 Operating Instructions (Version 1.26)
P/D 102406 HomePro
by ADVANCED CONTROL TECHNOLOGIES, INC.
20
Setting a device to “Exclude All On Only” will cause the Z-Wave device to
respond to All Off commands but not the All On command.
Setting a device to “Exclude All Off Only” will cause the Z-Wave device to
respond to All On commands but not the All Off command.
4.6.5 COPY REMOTE CONTROL TO ANOTHER WIRELESS CONTROLLER.
This menu is used to copy information from the Master Wireless Controller to other controllers, so that they may
command modules known by the Master Wireless Controller.
Note: The master controller must be the controller used to include new modules to the network and to reset modules.
A replication of the master controller is done as follows:
1. Select “Receive information” on the controller which should receive the information (i.e. the Secondary
Wireless Controller)
2. Select “Send information” and either “Identical copy” or “Only system information” on the controller that is
to send the information (i.e. the Master Wireless Controller).
3. Wait until transmission is completed and both the wireless controllers return to clock display.
4. If a transmission error occur. Please repeat from Step 1.