Amplicom PowerTel 720 Cordless Phone w/Answering Machine - Manual (Page 22)

4. Choose the desired recall timing setting (Short or Long) using REDIAL or FLASH
and press B or SAVE.
Insert a dialing pause
Insert a pause before the dial tone if the system requires an outside line which
takes awhile to connect.
CID/FLASH
OGM MEMO
To insert a dialling pause using your cordless handset, enter the number to
reach the outside line and then press
for two seconds. A P on the display
will show dialing pause is active.
Note: A dialing pause can be used with a phone number in the phone book.
Set the dial mode
There is a choice of two dialing modes: tone and pulse. The default setting is
TONE and this is the correct setting for use within the United States.
22
Service Center
u u
s se e o on n a a p pr riiv va at te e B Br ra an nC Ch h e ex xC Ch ha an nG Ge e