Amplicom PowerTel 720 Cordless Phone w/Answering Machine - Manual (Page 49)

Register the wrist shaker
Important: It is necessary to register the wrist shaker if it has become
de-registered from the telephone or if a new wrist shaker needs to be
registered.
At the wrist shaker:
1. Turn on the wrist shaker by pressing and holding
for about five seconds.
2. After the wrist shaker is On, press and hold again for about 12 seconds,
until the registration light flashes green. The wrist shaker will be in
registration for about 1 minute.
At the corded phone base:
3. Press and hold
PAGE
for at least 10 seconds, until Register
is displayed (for about 10 seconds).
Note: To located the registration key
PAGE
, see the At a Glance section for the
corded phone base at the beginning of this guide.
4. The registration light unit glows a steady green when the wrist shaker is
registered (i.e. it isn’t flashing).
Note: The registration light will flash green and red if the wrist shaker
either isn’t registered or is out of range.
1-866-AMPLICOM (267-5426)
49
w
rist
s
haker