Austin Hughes IPM-02 - Manual (Page 17)

www.austin-hughes.com UM-IPM-02-Q414V3 P.12
< 2.2 > IP dongle confi guration
Write down the new IP address & password
for < Setup > purpose, refer to P.20
Step 1 . Prepare a notebook computer to download the IP setup utilities from the link :
http://www.austin-hughes.com/support/utilities/infrapower/IPdongleSetup.msi
Step 2 . Double Click the IPDongleSetup.msi and follow the instruction to complete the installation
Step 3 . Go to each fi rst level PDU with the notebook computer & a piece of CAT. 5 / 6 cable to confi gure the
IP dongle by IP setup utilities as below. Please take the procedure for all IP dongles ONE BY ONE
After the completion of IP dongle connection, please take the following steps to confi gure the IP dongle :
IP dongle on 1st level PDU
To IP dongle
LAN port
To notebook computer
LAN port
CAT. 5 / 6 cable
Step 4 . Click “ Scan ” to search the connected IP dongle
Step 5 . Enter device name in “ Name ” ( min. 4 char. / max. 16 char. ). Default is “ Name ”
Step 6 . Enter device location in “ Location ” ( min. 4 char. / max. 16 char. ). Default is “ Rack_001 ”
Step 7 . Enter password in “ Password ” for authentication ( min. 8 char. / max. 16 char. ) Default is “ 00000000 ”
Step 8 . Enter new password in “ New password ” ( min. 8 char. / max. 16 char. )
Step 9 . Re-enter new password in “ Confi rm new password ”
Step 10 . Change the desired “ IP address ” / “ Subnet mask ” / “ Gateway ”, then Click “ Save ” to confi rm the changes
The default IP setting is as below:
IP address : 192.168.0.1
Subnet mask : 255.255.255.0
Gateway : 192.168.0.254
Reconnect the IP dongle with the network device
( router or hub ), after fi nish IP dongle confi guration.
Ensure the PDU in
power ON status