Austin Hughes IPM-01 - Manual (Page 32)

www.austin-hughes.com UM-IPM-01-Q213V2 P.28
10. Can the MTS / MT PDUs connect the KVM switch?
Yes, only CyberView IP KVM switch. In this connection, IP dongle will not be needed.
For the details, please fi nd the link below:
http://www.austin-hughes.com/support/usermanual/infrapower/UM-IPS-01.pdf
11. Does the IP dongle support web browser access?
Yes, the IP dongle features a browser-based built-in graphical user interface (GUI) that can confi gure,
monitor and power control to individual outlets.
For the details, please fi nd the link below:
http://www.austin-hughes.com/support/usermanual/infrapower/UM-PPS-01.pdf
< 4.2 > IP dongle
1. What is the IP dongle?
The IP dongle provides a simple and economical way to consolidate management of max. 16 pcs
MTS / MT PDUs, by a single IP connection to the network.
2. What is the IP setup utilities?
This is a windows application used to assign the IP address of IP dongle. You can download the IP
setup utilities from the link below:
http://www.austin-hughes.com/support/utilities/infrapower/IPdongleSetup.msi
3. Does the IP dongle support DHCP (Dynamic Host Confi guration Protocol)?
No, the IP dongle only works with static IP-address.
4. How can I reset the IP dongle password to the factory default value?
Press the reset button of IP dongle for at least 8 seconds to reset the IP dongle to the factory default
value as below:
IP address: 192.168.0.1
Password: 00000000
5. Will the reset of IP dongle affect the power to the outlets?
No, the IP dongle operates on a separate circuit, so the power to the outlets will remain unchanged.
6. How can I replace a failed IP dongle?
As the IP dongle is hot swappable, without power disconnection, you can unplug the RJ45 connector
and slide out the failed IP dongle from the MTS / MT PDU. Then replace a new one for the PDU and
re-confi gure the IP address to fi t your network setting. ( Please refer to the user manual P. 5 )