Bonaire Ducted RAC Inverter - Manual (Page 25)

Page 25
TROUBLESHOOTING
Your air conditioner will not operate!
Question Y/N Solution
Yes Refer to question 4
1.
Has the unit been
run since
installation?
No Check that the main switch is turned ON, Check and
replace the batteries in the controller (IR Handset
Only).
Yes Refer to question 3
2.
Is the unit installed
in a new home?
No Refer to question 4
Yes Refer to question 4
3.
Has the installer run
the unit?
No Check that the unit is turned ON at the main switch.
Contact your dealer to commission the unit.
Check and replace the batteries in the controller (IR
Handset Only).
Yes Press the reset buttons or turn the unit off then on to
reset unit. If the unit still does not start call for service.
(refer to solution 6 for reset instructions) NOTE:
Remember your system is fitted with a start-up and
changeover delay timer to prevent compressor
damage.
4.
Is the controller set
to operate in the
correct mode and is
the SET TEMP
higher or lower than
the room
temperature?
No Follow the instructions in ‘CONTROL NAVIGATION’
located at the beginning of this manual and set the
controller correctly.
Yes The air conditioner may be programmed to be OFF.
To operate the air conditioner manually press the
Manual / Auto button until the MANUAL is displayed.
Adjust the room SET TEMP as desired.
5.
Is the controller in
program mode?
No Refer to question 4
Yes Reset the unit. This can be done by:
1. Following the RESET procedure on ‘Page 28’, or,
2. Turn the appliance Off, then ON at the unit power
isolator
6.
Is RESET showing
on the controller
display?
No Unit should operate normally. If not contact your
authorised Climate Technologies service provider.
THIS TROUBLE SHOOTING GUIDE IS A REFERENCE ONLY.
FOR SERVICE OR WARRANTY REQUIREMENTS PLEASE REFER TO
THE WARRANTY SECTION OF THIS BOOK