Bonaire Ducted RAC Inverter - Manual (Page 5)

Page 5
INTRODUCTION
the air
Assembly
There is no assembly required of this Ducted Inverter Reverse Cycle Air Conditioner. Your Dealer or
installer will carry out all assembly and commissioning upon installation.
Operating Temperature Range
If the system is used when the temperatures are outside the operating ranges shown below, safety devices
may activate causing the system to stop.
If the system is used on heating below the minimum temperature ranges in the table below, the outdoor
heat exchanger may freeze and cause the unit to malfunction and stop. If the system is to be installed in
locations where the ambient temperature falls below the minimum operating ranges stated in the table
below, supplementary BOOST heating may be required (contact your dealer for advice on this option).
Although the controller will allow the operating set temperature to be adjusted between 16 to
31°C, it is important that the controller settings be maintained within the temperature ranges
shown in the table above:
The system is designed to provide comfort conditions of 18°C - 22°C for heating and 22°C -
26°C for cooling