Ditch Witch JT922 - Manual (Page 125)

Complete the Job - 124
JT922 Operator’s Manual
Rinse Equipment
CMW
Rinse Equipment
Using Optional Washwand
Connect the washwand at quick connect (1) at
rear of unit. Open valve (2) to start water flow.
Close valve to stop water flow.
Procedure
See “Prime Drilling Fluid Pump” on page 77.
Spray water onto equipment to remove dirt and mud. Some pressure might be needed to remove dried
mud from wrench area.
Incorrect procedures could result in death, injury, or property damage.
Learn to use equipment correctly.
NOTICE: Failure to prime the drilling fluid pump will cause flow fluctuations, which will
make it difficult to control the washwand. For instructions, see “Prime Drilling Fluid Pump”
on page 77.
Pressurized fluid or air could pierce skin and cause injury
or death. Stay away.
NOTICE: Do not spray water onto operator’s console. Electrical components could be damaged. Wipe
down instead.