Ditch Witch JT922 - Manual (Page 95)

Systems and Equipment - 94
JT922 Operator’s Manual
Anchor System
CMW
Drive Anchors
1. Use anchor rotation and thrust controls to
drive anchor into ground.
2. Anchor is set when cap top plate (1) rests
firmly on centering tube (2).
3. Repeat process for other anchor.
Remove Anchors
1. Use anchor rotation and thrust controls to
slowly remove anchor shaft from ground.
2. Repeat process for other anchor.
IMPORTANT: Carefully time anchor rotation
with anchor movement. Properly driven
anchors should thread into soil and should
not auger up soil.