Ditch Witch FXT60 - Manual (Page 91)

Service - 90
FX60/FXT60 Tier 4 Operator’s Manual
Recommended Lubricants/Service Key
CMW
®
Approved Fuel
This engine is designed to run on diesel fuel. Use only high quality fuel meeting ASTM D975 No. 2D,
EN590, or equivalent. At temperatures below 32°F (0°C) winter fuel blends are acceptable. See the engine
operation manual for more information.
Biodiesel blends up to 5% (B5) are approved for use in this unit. The fuel used must meet the
specifications for diesel fuel shown above. In certain markets, higher blends may be used if certain steps
are taken. Extra attention is needed when using biodiesel, especially when operating in cold weather or
storing fuel. Contact your Ditch Witch
®
dealer or the engine manufacturer for more information.
Approved Coolant
This unit was filled with John Deere
®
Cool-Gard
®
coolant before shipment from factory. Add only John
Deere Cool-Gard (p/n 255-006) or any fully-formulated, ethylene glycol based, low-silicate, heavy-duty
diesel engine coolant meeting ASTM specification D6210.
NOTICE: Use only Ultra Low Sulfur Diesel (less than 15ppm/ 15 mg/kg sulfur content) in this unit.
Operating with higher sulfur content will damage the engine and aftertreatment device.
NOTICE:
• Use only pre-diluted or concentrated coolant mixed with distilled water. Do not use tap water.
• Do not use water or high-silicate automotive-type coolant. This will lead to engine damage or
premature engine failure.
• Do not mix heavy-duty diesel engine coolant and automotive-type coolant. This will lead to coolant
breakdown and engine damage.