Ditch Witch RT120 Q - Manual (Page 104)

RT120Q Operator’s Manual
Plow - 103
Setup
CMW
Position Tractor
1. Fasten and adjust seat belt.
2. Start tractor. See page 76 for start-up procedures.
3. Drive to starting point. Move in line with planned trench.
4. Engage parking brake and verify parking brake indicator is on.
5. Lower backfill blade, if equipped.
6. If equipped with combo, set trench/plow switch to the plow position.
7. Lower plow to starting point of trench.
8. Turn ignition switch to STOP.
Attach Product
To Pull Product
1. Insert material into pulling grip.
2. Tape grip with duct tape.
IMPORTANT: If material must be at a constant depth, dig starting and target trenches.