User guide, 5 vector wiring – Eagle Tree Vector User Manual
Page 16
USER GUIDE
16
3.5 Vector Wiring
The Vector’s wire harnesses are shown below. Note that
a set of replacement wire harnesses is available (p/n VEC-
CAB-SET). Having additional sets make it easier to move
your Vector from model to model.
Video Harness – routes video signals, and provides
power from the Current Sensor/PSU to the Vector, and
optionally to your video transmitter, camera, and
microphone.
Audio Harness – this cable connects to your microphone,
and also to the audio output of your video transmitter.
Receiver Connection Harness – this cable connects
between the Vector and your RC receiver/LRS.
GPS Harness – this cable connects between the Vector and the GPS/Mag.
3.5.1 Vector Video Harness + Connecting your Video Camera and Transmitter
The Vector's innovative video harness makes it easy to connect your 5V or 12V cameras and transmitters
without keeping an electrician on standby. The figure below shows a typical hookup, with a 12V camera, 12V
transmitter, and a microphone.