Eagle Tree Vector - Manual (Page 88)

USER GUIDE
88
10 Description of Numeric Readouts
The following numeric readouts can be configured for display. Some require optional hardware.
Numeric Readout Name Description
Main Pack Voltage Voltage of the pack connected to the current sensor
Transmitter Voltage Voltage at the "Vid Tx” power connection of the video harness
Camera Voltage Voltage at the "Cam/Mic” power connection of the video harness
Receiver Voltage Voltage at the Vector’s servo outputs
Sensor Temperature Temperature of the optional temperature sensor
Ambient Temperature Approximate air temperature, obtained from the GPS/MAG sensor
Barometric Altitude Zero referenced altitude, from the onboard pressure sensor
Pitot Airspeed Airspeed from the optional pitot airspeed sensor
RPM RPM reading from the optional RPM sensor
Main Pack Current Current flowing through the current sensor
Main Pack Wattage Voltage X Current at the current sensor
Prop RPM (Headspeed) Same as RPM reading above
Main Pack mAH Used The milliamp hours through the current sensor since bootup
Mode Rx Input %
The measured pulsewidth at the Vector’s mode switch input (0% = 1 millisecond,
100% = 2 milliseconds)
Gain Rx Input % The measured pulsewidth at the Vector’s gain knob input, if used
Aileron Rx Input % The measured pulsewidth at the Vector’s aileron input
Elevator Rx Input % The measured pulsewidth at the Vector’s elevator input
Throttle Rx Input % The measured pulsewidth at the Vector’s throttle input
Rudder Rx Input % The measured pulsewidth at the Vector’s rudder input
Submode Rx Input % The measured pulsewidth at the Vector’s submode switch input, if used
Kill Switch Rx In % The measured pulsewidth at the Vector’s kill switch input, if used
2nd Aileron Rx In % The measured pulsewidth at the Vector’s 2 nd Aileron input, if used
2nd Elevator Rx In % The measured pulsewidth at the Vector’s 2 nd Elevator input, if used