Eagle Tree Vector - Manual (Page 33)

USER GUIDE
33
IMPORTANT: follow these instructions carefully. If you make a mistake, it may be impossible to
continue with stick menu configuration, since the Vector menus cannot be accessed unless the Vector knows
the mappings for the Mode switch and the control stick. If you find you cannot invoke the menus after running
the wizard, you will need to either rewire your receiver for standard receiver input mode (using the labeled
connectors of the receiver harness) and rerun the wizard, or use the software for SPPM/S.BUS™ configuration.
Wizard Prompt What to Do
Click Mode to Learn
PPM/SBUS For this step, toggle the switch that you want to be the Mode switch. If the
Vector detects the toggle, the wizard will advance.
Disconnect Motor/Toggle
Mode Make sure your motor(s) or propeller(s) are disabled, and toggle the Mode
switch up and down to continue. Note: all Vector outputs are disabled
during the wizard.
Throttle Up and Toggle Mode Move your throttle to the full upp throttle position, and toggle Mode.
Throttle Off/Toggle Mode Move your throttle to the off position, and toggle Mode.
Hold Aileron Left/Toggle Mod Hold your aileron stick full left, and while holding, toggle Mode.
Hold Elvtr Back(Climb)/Tog
Md Hold your elevator stick all the way back (for a climb), and while holding,
toggle Mode.
Hold Rudder Stick Left/Tog Md Hold the rudder stick all the way left, and while holding, toggle Mode.
Flip Submode if Used/Tog
Mode If you are going to use a Submode switch, move that switch to a new
position (don’t move it back) and toggle Mode. If you are not going to use
it, just toggle Mode without moving any switches.
Rotate Gain if Used/Tog Mode Rotate the Gain knob to a new position (make sure that it moves at least
40% of its maximum turn) and toggle Mode. If you are not going to use it,
just toggle Mode without moving any knobs.
Kill switch on if Used/Tog
Md If you wish to use a Kill switch for your multirotor, change its position
(hold it in the new position if it’s momentary) and toggle Mode. If you are
not going to use it, just toggle Mode without moving any switches.
Flip Flaps Sw if Used/Tog
Md If you wish to use a flap switch or knob with the Vector, change its position
and toggle Mode. If you are not going to use it, just toggle Mode without
moving any switches.
Learn Done! Clik Md to reboot The Vector has now learned your serial Rx mappings. Click the mode
switch to reboot, and continue with the steps below.
If you ever need to change your serial mappings later, just invoke the “Serial Rx Input Learn Wizard”
menu item in the Radio Control Settings menu.
5.4.2 Navigating the Stick Menus
Your Vector should now be configured so that you can access the stick menus.
Now toggle your mode switch twice (two rapid, full movements between the switch’s extents, in less than 2
seconds).