Eagle Tree Vector - Manual (Page 83)

USER GUIDE
83
9 Notification Messages
During boot-up and normal operation, the Vector constantly checks its status and settings, and the status of any
connected accessories. If an issue is detected, the Vector will display a message in the OSD notification area
either temporarily or until the issue is resolved, depending on the importance of the message.
The table below describes these messages, and what they mean. Note that it is unlikely you will ever see most
of these messages.
Onscreen Notification Meaning of Message
2nd Aileron Input not Detectd
You configured the Vector to receive a mixed 2 nd aileron signal from
your transmitter, but that signal is not detected. Check your wiring and
receiver settings.
2nd Ailrn Issue:Rerun Wizard!
You configured the Vector to receive a mixed 2 nd aileron signal from
your transmitter, but that signal was not correctly detected when you
ran the Receiver Analysis Wizard. Please check correct operation of the
2 nd output from your transmitter, and rerun the wizard.
2nd Elevatr Input not Detectd
You configured the Vector to receive a mixed 2 nd elevator signal from
your transmitter, but that signal is not detected. Check your wiring and
receiver settings.
2nd Elvtr Issue:Rerun Wizard!
You configured the Vector to receive a mixed 2 nd elevator signal from
your transmitter, but that signal was not correctly detected when you
ran the Receiver Analysis Wizard. Please check correct operation of the
2 nd output from your transmitter, and rerun the wizard.
2nd Rudd Issue: Rerun
Wizard!
You configured the Vector to receive a mixed 2 nd rudder signal from
your transmitter, but that signal was not correctly detected when you
ran the Receiver Analysis Wizard. Please check correct operation of the
2 nd output from your transmitter, and rerun the wizard.
2nd Rudder Input not Detected
You configured the Vector to receive a mixed 2 nd rudder signal from
your transmitter, but that signal is not detected. Check your wiring and
receiver settings.
Aileron Issue: Rerun Wizard!
When you ran the Receiver Analysis Wizard, the Vector did not detect
correct movement of the aileron input. Check your wiring and settings
and run the wizard again.
Ailron or Elevatr undetected!
The Vector did not detect your aileron and/or elevator signal during
boot. Either these wires are not connected correctly, or your receiver or
transmitter was not powered during boot.
Airframe Not Set
You have not yet set the airframe type, which is required to use the
Vector’s flight controller.
Airframe Type Change Detected
This message will appear, along with an image of the presently selected
airframe type, when you first boot the Vector after changing the
airframe type. You must OK the airframe type by clicking the mode
switch once while this message is displayed on the screen.
Altimeter not detected! If you repeatedly see this message, DON’T FLY and contact support.
Alt Hold Failing: Vib too hi!
The Vector has detected that there is too much vibration for altitude
hold to work correctly.
Alt Hold Reset: Vib too high!
The Vector has reset the altitude hold logic, due to continued
excessive vibration.
Alt Hold Failure: Vib too hi!
The altitude hold function has failed, due to continued excessive
vibration.