East Coast Supercharging ECS Alky C6 - Manual (Page 7)

Once this is done, the fender will move outward allowing clearance so that the factory
washer tank can be removed. I remove the hose from the factory washer motor and
allow tank to drain. At this time you’ll note the space behind the factory tank that is
where the pump will be mounted. There are 3 bolts securing the tank and one push
rivet on the neck. Pry out the push rivet and remove the 3 bolts. Tank can now be
removed. Once removed the pump can be placed. Note that the pump is longer and will
hang below the frame rail. So what I do is simply relocate the washer tank upwards 1
inch. This can simply be done by using two of the supplied self tapping screws and re-
drilling the tank upward. Drill a hole in the front and back. Back of tank will rest on top
of pumps cover.
You will only be allowed to use 3 of the supplied screws as the frame contours will only
allow that many. TIP.. The top screw will go on the edge of the frame rail
. And
confirm pump is flush with bottom of frame . TIP.. Once pump is located where
you want it, remove the bracket from pump and use it as a template where to drill
screws. A black marker works great.