East Coast Supercharging ECS Alky C6 - Manual (Page 8)

Once positioned, mark where the bolts will be installed and using a 3/8 socket on a drill,
use supplied SS bolts to affix pump to frame. There is a white wire with o-ring, it needs
to be attached to one of the bolts going into the chassis. Install straight fitting unto the
pump head, and 90 degree fitting into the outlet. The 90 will be pointing upward. Install
hand tight. Do not force or the head will crack on the pump. It’s a pipe thread, just
needs to be snug. Once pump and fittings are installed now get the feed hose and 90
degree fitting. Install on pump the hose and mark where to drill hole into factory tank.
The windshield washer tank will need to be modified to deliver the fluid to the pump
assembly. The modification entails drilling a 7/8 diameter hole in the bottom of the
tank, its lowest rear point, then installing the supplied push-in fitting. Make sure to
clean out all debris from drilling hole. To install fitting, insert rubber grommet into 7/8
hole, then using a lubricant like WD40 spray the grommet and simply push the fitting
in. NOTE>> the best advice is to use a UniBit step type drill bit that has 7/8 as its
largest size. Do not use a regular drill bit, else you will destroy the tank..
At this time attach hose onto fitting and pump. Next is install cap onto factory washer
motor and disconnect the wiring. Attach pump cable to pump. Next is drill hole into
firewall and feed pump cable through. TIP..The clutch port on an automatic is a great
place to drill the hole.
2) Relay mounting
The relay supplied is used to supply power to the controller using the fuel pump circuit
to drive its activation. It will go by the fuse box and get its power to the open lug from
the battery lug by the fuse box. The black wire on the relay goes to ground. The Gray
wire is the one that gets signal from the fuel pump circuit. And the red long wire gets
routed into the vehicle. The main purpose of this relay is to isolate the PAC controller
from any of the on-board electronics. Simply open box and loosen the main studs. Box
pries apart.