Echelon LonMaker - Manual (Page 89)

LonMaker User’s Guide 73
2. Enter the name of the new user name in the Name box, and the password in the Password and
Retype Password boxes. Note that both the user name and password are case sensitive.
3. Set the user interface, access, and privileges of the new user.
UI Setting Select the set of LonMaker and Visio menu that will be available to
the user. You have two choices:
• Maximum. This setting provides the user a full set of toolbars,
menus, and menu items for advanced use of the LonMaker tool.
• Minimum. This setting provides the user only the basic menus,
menu items, and toolbars necessary to use the LonMaker tool.
You change the UI setting while the drawing is open by opening the
LonMaker menu and then clicking Select Minimum/Select
Maximum UI.
Access Control Select the type of access the user has in the LonMaker drawing. You
have two choices:
• All Subsystems. The user has unrestricted access to all of the
subsystems in the network.
• Selection. The user’s access is restricted to the selected
subsystem. This option can only be applied to the root
subsystem or any one of the subsystems one level below it. If
you select the root subsystem, the user cannot access any of the
subsystems below it.
Privileges Select which actions the user can perform on objects in the
LonMaker drawing.
You can set privileges for reading, modifying, changing the name,
adding, deleting, commissioning, and replacing objects, as well as
the use of plug-ins for the objects. The objects for which you can set