Echelon LNS - Manual (Page 361)

LNS Programmer's Guide 347
Figure C.3 Example Monitor and Control Application
The following section describes how you can use this dialog, and reference the location of
the source code you can view to see how the tasks you perform are accomplished using
LNS.
1. First, select a client type. This determines how the example monitor and
control application will connect to the LNS Server. The different client
types are introduced in Chapter 3 of this document. The client type you
select determines which networks and network interfaces will be
available from the Network Name and Network Interface drop-down
boxes you will use in the following steps.
Note that for remote client types, you will need to have the LNS Server
running on the same PC that contains the LNS global database. This is
the PC on which you created the network with the network management
application.
In addition, if you selected Remote Lightweight Client, you will need
to perform the following steps before proceeding to step 2: