Electrocompaniet EMP 1 - Manual (Page 23)


23. To input your favorite tracks/chapt.
1 Use the numeric keypad (0-9) to enter a
valid track/chapter number.
2 Use ◄►▲▼ to move the cursor to the
next position.
• If the track number is more than ten,
press : to open the next page and
proceed with programming or,
• Use ◄►▲▼ to highlight [NEXT] on
the program menu, then press ENTER/
OK.
3 Repeat steps 1-2 to input another track/
chapter number.
To remove a track
4 Use ◄►▲▼ to move the cursor to
the track you want to remove.
5 Press ENTER/OK to remove this track
from the program menu.
Note:
On SA-CO discs. you can program tracks on
the CD layer.
Program: Disc
You can playback discs in the order you want
by programming the discs to be played. You
can store up to 5 discs.
1 In ‘GENERAL SETUP PAGE’, press
▲▼ to highlight [PROGRAM], then
press ► to select [FDS],
2 Press ENTER/OK to confirm.
To input your favorite discs
1 Use the numeric keypad (0-9) to enter a
valid disc number.
2 Use ◄►▲▼ to move the cursor to the
next position.
3 Repeat steps 1-2 to input another disc
number.
If you want to remove a disc
4 Use ◄►▲▼ to move the cursor to the
disc you want to remove.
5 Press 0 on the numeric keypad (0-9) to
remove this disc from the program menu.
To start program playback
Use ◄►▲▼ to highlight [START] on
the program menu, then press ENTER/
OK
• Playback starts for the selected tracks or
discs in the programmed sequence.
To exit program playback
Use ◄►▲▼ to highlight [EXIT] on the
program menu, then press ENTER/OK
Setup Menu -
General
(1) DISC: -
(2) DISC: -
(3) DISC: -
(4) DISC: -
(5) DISC: -
START EXIT
FAVORITE DISC SELECTION