Elenco Digital / Analog Trainer Kit Version - Manual (Page 14)

MOUNT COMPONENTS TO PANEL
Push the illuminated switch into the hole in the top
panel with the lugs as shown in Figure Q.
Install the fuse holder with the side lug in the position
shown in Figure Q. Fasten the fuse holder in place
with the nut as shown in Figure Q. Unscrew the cap
and insert the fuse into the holder.
There is a raised area on the back side of the top
panel.
Screw the spacer to the raised area by
inserting a 4-40 x 1/4” flat head screw into the hole in
the raised area from the top side of the panel (see
Figure R).
When mounting the bredboard, use the holes shown in
Figure S. Mount the bredboard with two #4 x 1/4” AB
black screws from the back side of the top panel as
shown in Figure R. The negative (blue) stripe should
be on top and the numbers reading from left to right
should start with number 1 (see Figure T). CAUTION:
Do not remove the paper backing from the back of
the bredboards.
Do not over-tighten the black
screws.
Figure S
-13-
Spacer
4-40 x 1/4”
Flat Head
Screw
Top Panel
Bredboard
#4 x 1/4” AB Screws
Figure R
a
e
b
c
d
f
j
g
h
i
1 5 1
0
ON
30VAC
+5
+12
–12
15VAC
OFF
15VAC
REGULATED
POWER SUPPLY
+ 2 0 C D
– 2 0 C D
GND
Figure T
V V
Back Side - Lower
Right Corner
Figure Q
Side Lug
Illuminated Switch
Top Panel
Plastic Washer
Fuse Holder
Nut