Elenco Digital / Analog Trainer Kit Version - Manual (Page 6)

Figure C
Mount down flush with PC board. The
value may be marked on the on the
back side of pot.
Cut off excess lead length after
soldering.
Figure B
Note: One side of the
bracket is longer. Mount
this side to the PC board.
Mount the bracket to the
top legend side of the PC
board with a 4-40 x 1/4”
screw and fiber washer.
Figure A
Mount the connector as shown and solder the
pins of the connector.
-5-
INSTALL COMPONENTS TO PC BOARD
Start Here
S1 - 5-Pin Connector
(see Figure A)
L-Bracket
(see Figure B)
VR4 - 100k
Ω
Pot
VR3 - 1k
Ω
Pot
(see Figure C)
S3 - 3-Pin Connector
S2 - 3-Pin Connector
(see Figure A)
L-Bracket
(see Figure B)
C8 - 0.1
µ
F Mylar (104)
(see Figure D)
Bottom Left Corner of PC Board
Top Left Corner of PC Board
Figure D
Bend the capacitor at a 45 O
angle before soldering. Cut off
excess leads.
Cut off tab
PC Board
4-40 x 1/4”
Screw
Top Legend
Side of
PC Board
Fiber
Washer