Elenco Digital / Analog Trainer Kit Version - Manual (Page 22)

-21-
Figure AA
Figure BB
Figure CC
INSTALL COMPLETED UNIT INTO CASE
Latch the case lid down. Remove the protective backing from the case label. Stick the label in the depression
in the middle of the case lid.
Tie a knot in the line cord 12” from the switch. See Figure AA for the location of the line cord hole in the case.
Insert the line cord into the hole through the slot. To open up the slot, press down on one side of the slot
(see Figure BB). Insert the bushing into the hole and pull on the line cord until the knot is snug against the
bushing.
Insert the unit into the case at a 45 O angle, bottom edge first. Secure into place with four 6 x 3/8” chrome
screws in the corner holes of the panel.
The line can be neatly stored in the bin shown in Figure AA. Gather up the line cord and insert it into the bin.
Insert the line cord fastener into the slots to the hole in place, as shown in Figure CC.