Elenco Digital / Analog Trainer Kit Version - Manual (Page 31)

-30-
INSTALL COMPONENTS TO PC BOARD
Start Here
J18 - Jumper Wire
(see Figure A)
R13 - 8.2k
Ω
5% 1/4W Resistor
(gray-red-red-gold)
J17 - Jumper Wire
(see Figure A)
C18 - .001
µ
F (102) Mylar
(see Figure EA)
R6 - 12k
Ω
5% 1/4W Resistor
(brown-red-orange-gold)
Figure H
Mount down flush with
PC board.
The value
may be marked on the
back side of pot.
Cut off excess lead
length after soldering.
Potentiometers
Switches
Figure I
Mount down flush with PC board.
Note: SW2 has 12 pins and SW3
has 16 pins.
VR6 - 100k
Ω
Pot
(see Figure H)
VR5 - 10k
Ω
Pot
(see Figure H)
VR7 - 100k
Ω
Pot
(see Figure H)
SW2 - SW Rotary 12-Pin
(see Figure I)
SW3 - SW Rotary 16-Pin
(see Figure I)
Continue
C21 - 1
µ
F 50V Electrolytic
(see Figure D)
C22 - 10
µ
F 25V Electrolytic
(see Figure D)
C20 - .1
µ
F (104) Mylar
(see Figure EA)
C19 - .01
µ
F (103) Mylar
(see Figure EA)
Cut off
tab
Cut off
tab