ENMET MX-52 - Manual (Page 10)

ENMET Corporation MX52 C ONTROL
6
4.0 Installation 4.0 Installation 4.0 Installation 4.0 Installation
4.1 Installation recommendations
The MX52 C ONTROL can be installed in any area without a hazardous atmosphere. It should preferably be placed in a
ventilated and monitored location, such as guardhouse, control room, instrumentation room, etc.
The control can be mounted in any standard 19″ rack. See Figure 1 for dimensions. Optional enclosures and wall
shelves are available.
Before making any connections, switch off the power using the main On/Off switch below and to the left of the
FRONT circuit (see Figures 4 and 10).
Power Supply Terminal
•
•
•
•
•
•
•
Figure 5: Power Board and Module
Earth Ground
Terminal
Note: Power connections are located on a terminal strip in this location.
Note the location of the relevant positions as labeled on the terminal
strip and wire accordingly. Positions of the AC & DC contacts may
vary depending on the required power supply